DE
EN

MFT-FOX VT-2L-HANGERS-UNDERCUT ANCHORS


The system consists of profiles plus wall brackets that eliminate thermal bridging and is specifically designed for vertical / horizontal substructures employing undercut anchors for concealed fastening in ventilated facades.

The wall brackets are supplied with a powder-coated base plate, according with the method of installation
on the base material — anchors, screws and direct fastening — with different hole geometries in the base plate.

The wall brackets are designed with both fixed and flexible points to allow for thermal expansion of the profile. The fixed point takes the weight of the panels and substructure and the proportional wind loads, while the flexible point only assumes the proportional wind loads.

Vertical profiles are connected to the wall brackets with specially designed screws for fixed and flexible points. This allows virtually frictionless movement of the profiles relative to the wall brackets and keeps the profile connected by the fixed point in place. The flexible point makes sure that no additional loads are applied to the substructure by expansion forces exerted by the profile.

Adjustment of the profiles relative to the wall brackets is assisted by a «helping hand». The helping hand keeps the profile in position whilst the profile is being fastened with screws, allowing fast connection to the bracket. With this system, wall tolerances of up to 40 mm can be perfectly compensated. The wall brackets are available in lengths from 140 mm to 320 mm.

The base plate of the bracket is powder coated for corrosion resistance. The horizontal hanger profiles for this lengthways application are fastened to the vertical profiles. Fixed points are created by placing 2 screws in the elongated holes while flexible points consist of 1 screw. Hangers are differentiated according to their function, i.e. fixed, levelling and levelling plus fastening.

Advantages

  • Flexible design using fixed and flexible points
  • 40 mm adjustment capability of the profiles on the wall brackets
  • Bracket length from 140 mm to 320 mm
  • Brackets can be installed using a range of methods — anchors, screws or direct fastening
  • Powder-coated base plate for corrosion resistance
  • Substructures can be designed with PROFIS Facade to create technically sound, cost-efficient solutions
  • Can be used with all panels with approval for the undercut fastening

System downloads

System components

Brackets:

  • MFT-FOX VT M / L

Bracket fastener:

  • HUS-HR
  • HRD-H
  • HST-R
  • HSA-R
  • HIT-HY
  • S-MD

Profiles:

  • MFT-L
  • MFT-HP 200

Profile fastener:

  • S-AD
  • S-MD51LS

Connector fastener:

  • S-MD51LS

Other fasteners:

  • MFT-JS 6×15 A4
  • S-MD03S 5,5×32

Accessories:

  • Hangers

To order products, visit your local Hilti page.